Meets or exceeds the performance requirements of
AS 3791 100R12, EN856 Type R12, EN 856 Type 4SP (-12 and above),
ISO 3862 Type 6, SAE 100R12.

Recommended For: Very high pressure hydraulic oil lines, in applications where the outside cover of the hose is subject to sliding abrasion that may cause premature failure of standard hoses. The very high abrasion resistant properties of the polyethylene sheathed cover, combined with the extra high working pressures and excellent impulse life when tested to SAE 100R12 test conditions, are designed to increase service life and minimize equipment downtime.
Tube: Black, oil resistant synthetic rubber. (Neoprene).
Reinforcement: Four layers of alternated, spiraled high tensile steel wire.
Cover: Black, abrasion resistant and oil resistant rubber sheathed with a layer of extremely abrasion resistant polyethylene. The maximum weight loss of the cover under ISO 6945 method of test for abrasion resistance is less than 0.2% (less than 0.002 gms) of that allowed by DIN 20023 and EN 856. Highly visible layline branding for easy and permanent identification. No skiving required with Bitelok T700 Series Crimp Couplings.
Temperature Range: From -40°C to +121°C (-40°F to +250°F). For water, emulsions etc.  
Working Pressure: Dynamic working pressures (in systems with pressure surges or variable loads) are based on 4:1 minimum burst to working pressure safety factor. Static working pressures (in systems with constant loads without pressure spikes) are based on 3:1 minimum burst to working pressure safety factor.

Crimp Couplings for above hose