Meets or exceeds the performance requirements of SAE 100R15.
“DNV” Det Norske Veritas Type Approval is pending.

Recommended For: Extremely high pressure hydraulic oil lines, in
applications where the outside cover of the hose is subject to abrasion that may cause premature failure of standard hoses. Maximum Working Pressure of 420 Bar / 6000 PSI in all sizes. The very high abrasion resistant properties of the cover, combined with the extra high working pressures and excellent impulse life when tested to SAE 100R15 test conditions, are designed to increase service life and minimize equipment downtime.
Tube: Black, oil resistant rubber. (Neoprene).
Reinforcement: Four layers of alternated, spiraled high tensile steel wire for sizes -12 to -20. Six layers of alternated, spiraled high tensile steel wire for size -24.
Cover: Black, extra abrasion resistant and oil resistant synthetic rubber. ''FRAS'' Flame Resistant and Anti-Static. The maximum weight loss of the cover under ISO 6945 method of test for abrasion resistance is less than 10% (less than 0.10 gms) of that allowed by DIN 20023 and EN 856. Highly visible layline branding for easy and permanent identification.
Temperature Range: From -40°C to +121°C (-40°F to +250°F). For water, emulsions, etc.
Working Pressure: Dynamic working pressures (in systems with pressure surges or variable loads) are based on 4:1 minimum burst to working pressure safety factor. Static working pressures (in systems with constant loads without pressure spikes) are based on 3:1 minimum burst to working pressure safety factor.

Crimp Couplings for above hose