Ryco hydraulic hose fittings assemblies hoses

Meets or exceeds the performance requirements of AS 3791 100R5, SAE100R5, SAE J1402 Type AII (up to -12 size).
Recommended For: Medium to high pressure hydraulic applications, where resistance to either petroleum-base or phosphate ester** fluid is required. The small bend radius, temperature resistance and light weight of RYCO RQP5 hose make it suitable for under the bonnet automotive/ trucking applications including hydraulic oil, diesel fuel, filtration, lubrication oil, transmission oil coolers and some power steering applications. Sizes RQP54 to RQP512 also comply with SAE J1402 Type AII ''Automotive Air Brake Hose'' for use in truck ''air brake systems including flexible connections from frame to axle, tractor to trailer, trailer to trailer, and other unshielded air lines that are exposed to potential pull or impact''. May be used with compressed air if maximum dynamic working pressure as specified in the tables is reduced by 30%. RQP5 hose is normally used where there is minimal abrasion to the outside cover. If abrasion is likely, support the hose away from the source of abrasion using mounting clamps, or protect with RWA Wire Armour or RSG Spiral Guard. RQP5 is a reduced bore hose. It has a similar Inside Diameter to steel or copper tubing of the same nominal (outside diameter) size.
Tube: Black synthetic rubber, specifically compounded for temperature and chemical resistance. Reinforcement: Polyester inner braid covered with one braid of high tensile steel wire. Cover: Blue polyester braid. Skiving of cover is not required. Temperature Range: Petroleum-base fluids from -40°C to +150°C (-40°F to +302°F); water/oil emulsions to +121°C (+250°F); diesel fuels to +93°C (+200°F). Air to +121°C (+250°F) (max. working pressure must be reduced by 30%). Some phosphate ester fluids in the temperature range of -40°C to +82°C (-40°F to +180°F). Not suitable for use with aerospace type phosphate esters such as Monsanto Skydrol 500B, Stauffer Aero-Safe 2300W and Chevron Hy-jet IV. Working Pressure: Dynamic working pressures (in systems with pressure surges or variable loads) are based on 4:1 minimum burst to working pressure safety factor. Couplings: Field Attachable V Series (sizes -04 to -32)	Crimp Couplings for above hose

*Field Attachable Couplings should not be used on RQP2 Hose at maximum working pressure when temperature exceeds 121 Deg C (250 Deg F).
Field Attachable Couplings may be used on RQP2 Hose at over 121 Deg C but at reduced working pressure.
***When using B Series Field Attachable Couplings on RQP2 Series Hose, cover of hose must be skived at ends.