Meets or exceeds the performance requirements of AS 3791 100R2AT,
DIN 20022 - 2SN, EN 853 Type 2SN, ISO 1436 Type 2AT, SAE 100R2AT.

Recommended For: High pressure hydraulic oil lines in applications where the outside cover of the hose is subjected to sliding abrasion that may cause premature failure of standard hoses. The extremely high abrasion resistant properties of the polyethylene sheathed cover, combined with the high working pressures and excellent impulse life when tested to EN 853 Type 2SN / SAE 100R2AT test conditions, are designed to increase service life and minimise equipment downtime.
Tube: Black, oil resistant synthetic rubber. (Nitrile).
Reinforcement: Two braids of high tensile steel wire.
Cover: Black, abrasion resistant and oil resistant rubber sheathed with a layer of extremely abrasion resistant polyethylene. The weight loss of the cover under ISO 6945 method of test for abrasion resistance is less than 0.2% (less than 0.001 gms) of that allowed by DIN 20022-2SN and EN 853 Type 2SN. Highly visible layline branding for easy and permanent identification. No skiving required with Bitelok T200 & T700 Series Crimp Couplings and L Series Field Attachable Couplings.
Temperature Range: From -40°C to +100°C (-40°F to +212°F). For water, emulsions etc.  
Working Pressure: Dynamic working pressures (in systems with pressure surges or variable loads) are based on 4:1 minimum burst to working pressure safety factor. Static working pressures (in systems with constant loads without pressure spikes) are based on 3:1 minimum burst to working pressure safety factor.

Crimp Couplings for above hose