TigerClamp

Spiral Double Bolt Clamps

For use on Tigerflex hoses with convoluted cover (counter-clockwise spiral only).

For adequate holding power, a single clamp may be used on each end for 1 1/2" - 4" ID hose.  Two clamps are recommended for each end on 5" ID hose and larger.

Note: Use of pneumatic air tools for tightening purposes is not recommended due to potential clamp damage caused by excess torque.  Both hex nuts should be tightened equally to prevent possible leakage.  If sockets are used, they should be deep well sockets.